Kelly Green Low Cure- Low Temp Ink Screen Printing Poly Ink

Kelly Green Low Cure - Low Temp Screen Printing Poly Ink  

The Kelly Green I-30-4053LC Series is WM’s most versatile series on the market, enabling printers to print on the most difficult substrates. Not only does this system hold up to the worst bleeders, but at the lower cure temps it could save a shop a ton of money in reduced energy costs.

Screen Printing Plastisol Ink

Wm Plastics Kelly Green Low Cure - Low Temp Poly Ink  screen printing plastisol ink are perfect for all screen printing shops large or small. Our inks are very good on automatic screen printing presses and or manual screen printing presses.

Non-Phthalate/PVC Plastisol Inks (LC Inks)

• • The LC Series is WM’s most versatile series on the market, enabling printers to print on the most difficult substrates. Not only does this system hold up to the worst bleeders, but at the lower cure temps it could save a shop a ton of money in reduced energy costs.

• • Bleed Resistance: Excellent

• • Opacity: High

• • Storage: 70 to 80 F. Due to the ability to cure at low temperatures, this is extremely important. Ink will become thicker over time but can be reduced to a printable viscosity.

• • Mesh: 61-230

• • Stencil: Any direct emulsion or capillary film.

• • Wet on Wet Printing: Can be printed wet-on-wet to increase production.

• • Modifications: Modifications are not recommended unless completely necessary. To reduce viscosity, use Curable Reducer (I10-9906), improve stretch use G&S Base (I10-1020) & puff use Puff Additive (I10-9903). ANY modification will effect Low Cure properties.

• • Squeegee Hardness & Angle: Medium to hard at a 45-degree angle.

• • Flashing: 700ºF for 3-5 seconds, just enough for the surface to be tack free. Squeegee Blade: Sharp.

• • Fusion/Curing: 230º º F/121 C for 1 ½ – 2½ minutes. º º 325 F/163 C for 1 to 1 ½ minutes.

• • Wash-up: Any plastisol cleaner.

• • Special Notes: PVC inks are thermoplastic compounds that require heat to fuse or cure. If ink rubs off on a white cloth or cracks, temperature and/or dwell time should be increased. Do not dry clean and always test on fabric to be printed.